Checking bulbs

With all doors closed, apply the parking brake and turn the ignition switch to the ON position without starting the engine. The following lights will come on:

The following lights come on briefly and then go

The following lights come on briefly and then go off (if so equipped):

If any light does not come on, it may indicate a

If any light does not come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system checked by a NISSAN dealer.

Some indicators and warnings are also displayed on the vehicle information display between the speedometer and tachometer. (See “Vehicle information display” later in this section.)

    See also:

    Programming HomeLink for Canadian customers
    Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink , continue to press and hold the HomeLink b ...

    How to use the STATUS button
    The STATUS button is used to display system information. Three different split screens of information are available. Press the STATUS button multiple times to cycle through these screens as fo ...

    Call volume
    Adjusting the incoming or outgoing call volume may improve clarity if reception between callers is unclear. ● Incoming call—adjusting this setting allows you to hear a difference in volu ...