DOOR position

When the switch is in the DOOR position 2 the map lights will illuminate under the following conditions:
- ignition switch is turned to the LOCK position
— remain on for about 15 seconds.
- doors are unlocked by pushing the unlock button Intelligent Key) (on the keyfob or Intelligent Key) or the request switch (Intelligent Key system equipped model), with the ignition switch in the LOCK position
— remain on for about 15 seconds.
- any door is opened and then closed with the ignition switch in the LOCK position
— remain on for about 15 seconds.
- any door is opened with the ignition switch in the ACC or ON position
— remain on while the door is opened.
When the door is closed, the lights go off.

The lights will turn off after 30 minutes when the lights remain illuminated to prevent the battery from becoming discharged.

    See also:

    Operating the HomeLink universal transceiver
    The HomeLink Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply press the appropriate programmed HomeLink Universal Transceiver button ...

    Clearing the programmed information
    Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). ...

    Training procedure
    1. Position the vehicle in a reasonably quiet outdoor location. 2. Sit in the driver’s seat with the engine running, the parking brake on, and the transmission in Park. 3. Push and hold the ...