Servicing air conditioner

The air conditioner system contains

The air conditioner system contains refrigerant under high pressure. To avoid personal injury, any air conditioner service should be done only by an experienced technician with the proper equipment.

The air conditioner system in your vehicle is charged with a refrigerant designed with the environment in mind.

This refrigerant will not harm the earth’s ozone layer. However, it may contribute in a small part to global warming.

Special charging equipment and lubricant are required when servicing your vehicle’s air conditioner.

Using improper refrigerants or lubricants will cause severe damage to the air conditioner system. (See “Air conditioning system refrigerant and lubricant recommendations” in the “9. Technical and consumer information” section.) A NISSAN dealer will be able to service your environmentally friendly air conditioner system.

Air conditioner filter

The air conditioner system is equipped with an air conditioner filter which collects dirt, pollen, dust, etc. To make sure the air conditioner heats defogs, and ventilates efficiently, replace the filter according the specified maintenance intervals listed in a separate maintenance booklet. To replace the filter, contact a NISSAN dealer.

The filter should be replaced if the air flow decreases significantly or if windows fog up easily when operating the heater or air conditioner.

Operating tips (for automatic air conditioner)

    See also:

    Locking with key
    The power door lock system allows you to lock or unlock all doors at the same time. Turning the key toward the front 1 of the vehicle locks all doors. Turning the key one time toward the rear 2 ...

    Voice recognition settings
    The available settings of the NISSAN Voice Recognition system are described. 1. Select “Voice Recognition”. 2. You can confirm the page by scrolling the screen. ...

    Heated seats (if so equipped)
    The front seats are warmed by built-in heaters. The switch is located on the center console. 1. Start the engine. 2. Push the LO or HI position of the switch, as desired. The indicator light in ...