Accelerator downshift — In D position —
For passing or hill climbing, fully depress the accelerator pedal to the floor. This shifts the transmission down into a lower gear, depending on the vehicle speed.
See also:
Map lights (if so equipped)
Map lights (if so equipped)
To turn the map lights on, press the button. To
turn them off, press the button again.
Do not use for extended periods of time
with the engine stopped. This cou ...
Maximum load limits
Maximum trailer loads
Never allow the total trailer load to exceed the
value specified in the Towing
Load/Specification chart found later in this section.
The total trailer load equals trailer w ...
Clearing the programmed information
Individual buttons cannot be cleared. However,
to clear all programming, press and hold the two
outside buttons and release when the indicator
light begins to flash (approximately 20 seconds). ...
