Moisture

Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion.

Wet floor coverings will not dry completely inside the vehicle, and should be removed for drying to avoid floor panel corrosion.

    See also:

    Installing top tether strap
    First, secure the child restraint with the LATCH lower anchors (rear outboard seat positions only) or the seat belt, as applicable. 1. Flip up the anchor cover 1 from the anchor point which is l ...

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint ...

    Jump starting
    If jump starting is necessary, see Jump starting in the In case of emergency section of this manual. If the engine does not start by jump starting, the battery may have to be replaced. Contact ...