System operation

The automatic drive positioner system will not work or will stop operating under the following conditions:

- When the vehicle speed is above 4 MPH (7 km/h).

- When any of the memory switches are pushed while the automatic drive positioner is operating.

- When the adjusting switch for the drivers seat is turned on while the automatic drive positioner is operating.

- When the seat has been already moved to the memorized position.

- When no seat position is stored in the memory switch.

- When the shift selector is moved from P (Park) to any other position.

- When the drivers door remains open more than 45 seconds and the ignition switch is not in the ON position.

The automatic drive positioner system can be adjusted and canceled for vehicles with navigation system. See Comfort & Convenience settings in the Monitor, climate, audio, phone and voice recognition systems section of this manual.

    See also:

    Pulling a stuck vehicle
    WARNING To avoid vehicle damage, serious personal injury or death when recovering a stuck vehicle: ● Contact a professional towing service to recover the vehicle if you have any questions ...

    Adjustable headrest (if so equipped)
    The adjustable headrests supplement the other vehicle safety systems. They may provide additional protection against injury in certain rear end collisions. Adjust the headrests properly, as ...

    Vehicle Dynamic Control (VDC) OFF switch
    The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to ...