NISSAN vehicle immobilizer system

The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key.

If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on the key ring), restart the engine using the following procedure:

1. Leave the ignition switch in the ON position for approximately 5 seconds.

2. Place the ignition switch in the OFF or LOCK position, and wait approximately 10 seconds.

3. Repeat steps 1 and 2.

4. Restart the engine while holding the device (which may have caused the interference) separate from the registered key.

If the no start condition re-occurs, NISSAN recommends placing the registered key on a separate key ring to avoid interference from other devices.

    See also:

    USB interface (models without Navigation System) (if so equipped)
    Connecting a device to the USB input jack The USB input jack is located in the center console. Open the protective cover (1) on the USB jack, then insert the USB device into the jack. When a ...

    Brake system
    The brake system has two separate hydraulic circuits. If one circuit malfunctions, you will still have braking at 2 wheels. ...

    Map lights
    To turn the map lights on, press the light lens. To turn them off, press the lens again. CAUTION Do not use for extended periods of time with the engine stopped. This could result in a discharged ...