Checking engine oil level

QR25DE engine

VQ35DE engine

1. Park the vehicle on a level surface and apply
the parking brake.
2. Start the engine and let it idle until it reaches
operating temperature.
3. Turn off the engine. Wait more than 10
minutes for the oil to drain back into
the oil pan.
4. Remove the dipstick and wipe it clean. Reinsert
it all the way.
5. Remove the dipstick again and check the oil
level. It should be between the H (High) and
L (Low) marks B . This is the normal operating
oil level range. If the oil level is below
the L (Low) mark A , remove the oil filler cap
and pour recommended oil through the
opening. Do not overfill C .
6. Recheck oil level with the dipstick.
It is normal to add some oil between oil maintenance intervals or during the break-in period, depending on the severity of operating conditions.
CAUTION
Oil level should be checked regularly. Operating the engine with an insufficient amount of oil can damage the engine, and such damage is not covered by warranty.
See also:
Locking with key
Drivers side
The power door lock system allows you to lock or
unlock all doors at the same time.
Turning the key toward the front (1) of the vehicle
locks all doors.
Turning the key one time ...
Locking doors
1. Turn the ignition switch to the LOCK
position.1
2. Carry the Intelligent Key with you.
3. Close all the doors.2
4. Push the LOCK button 1 on
the
Intelligent Key.
5. All the doors and the ...
Locking with key
Locking with key
The power door lock system allows you to lock
or unlock all doors simultaneously.
- Turning the driver’s door key cylinder to the
front of the vehicle 1 will lock all doors ...
