Installing covers to rear parcel shelf

CAUTION

CAUTION

Make sure that the hinge is completely aligned with the pin. If the pin is forced into position, it may break.

Install the top tether anchor cover or key cylinder cover as follows:

1. With the pin on one end kept free of its hinge 1 , align the pin of the other end and slide it into the hinge 2 .

2. With the first pin in position 2 , align the

2. With the first pin in position 2 , align the second pin with its hinge slot 1 and push down on the cover to completely engage it. A snap sound will be heard.

3. Close the cover.

3. Close the cover.

    See also:

    Suggested up-shift speeds
    The following are suggested vehicle speeds for shifting into a higher gear. These suggestions relate to fuel economy and vehicle performance. Actual upshift speeds will vary according to road cond ...

    All-Wheel Drive (AWD) (if so equipped)
    - For AWD equipped vehicles, do not attempt to raise two wheels off the ground and shift the transmission to any drive or reverse position with the engine running. Doing so may result in ...

    Outside the vehicle
    The maintenance items listed here should be performed from time to time, unless otherwise specified. Doors and engine hood Check that the doors and engine hood operate properly. Also ensure t ...