Nissan vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key.
If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on the key ring), restart the engine using the following procedure:
1. Leave the ignition switch in the ON position for approximately 5 seconds.
2. Place the ignition switch in the OFF or LOCK position, and wait approximately 10 seconds.
3. Repeat steps 1 and 2.
4. Restart the engine while holding the device (which may have caused the interference) separate from the registered key.
If the no start condition re-occurs, NISSAN recommends placing the registered key on a separate key ring to avoid interference from other devices.
See also:
Tire and loading information label
The cold tire pressure is shown on the Tire and
Loading Information label. The label is located as
shown. ...
Programming HomeLink for Canadian
customers
Prior to 1992, D.O.C. regulations required handheld
transmitters to stop transmitting after 2 seconds.
To program your hand-held transmitter to
HomeLink , continue to press and hold the
HomeLink b ...
Car Not Go
The Cube's four-cylinder engine offers up modest power at best, and it emits
a muffled roar when pushed hard. There's little fun to be had at higher revs,
which might have sufficed a decade ago. T ...