Hood
Hood
1. Pull the hood lock release handle 1 located below the instrument panel until the hood springs up slightly.
2. Locate the lever 2 in between the hood and grille and push the lever sideways with your fingertips.
3. Raise the hood 3 .
4. Remove the support rod 4 and insert it into the slot on the underside of the hood 5 .
When closing the hood, return the support rod to its original position, lower the hood to approximately 12 inches (30 cm) above the latch and release it. This allows proper engagement of the hood latch.
● Make sure the hood is completely closed and latched before driving. Failure to do so could cause the hood to fly open and result in an accident.
● If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.
See also:
Rocking a stuck vehicle
If your vehicle is stuck in sand, snow, mud, etc.,
use the following procedure:
1. Turn off the Vehicle Dynamic Control (VDC)
system.
2. Make sure the area in front and behind the
vehicle is ...
Cargo Bed Utility
The cargo bed in King Cab models is 73.3 inches long, 58.8 inches wide (44.4
inches between the wheel wells) and 18 inches tall.
Cars.com editor Joe Bruzek took the Frontier on a junkyard run to p ...
Changing a flat tire
If you have a flat tire, follow the instructions below:
Stopping the vehicle
1. Safely move the vehicle off the road and
away from traffic.
2. Turn on the hazard warning flashers.
3. Park on a l ...