Heating
This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and outboard vents.
1. Push the 
button to the off position for
normal heating.
2. Turn the air flow control dial to the
position.
3. Turn the fan control dial to the desired position.
4. Turn the temperature control dial to the desired position between the middle and the hot position.
See also:
Initialization
When the ignition switch is placed in the ON
position, NISSAN Voice Recognition is initialized,
which takes a few seconds. If the
button is
pressed before the initialization completes, the
syst ...
Top tether anchor point locations
Top tether anchor point locations
Anchor points are located on the floor behind
the outboard and center seating positions.
The child restraint top tether strap must be used
when installing chi ...
Before starting the engine
- Make sure the area around the vehicle is
clear.
- Check fluid levels such as engine oil, coolant,
brake fluid, and window washer fluid as
frequently as possible, or at least whenever
you re ...