Starting the vehicle

1. After starting the engine, fully depress the foot brake pedal before moving the shift selector out of the P (Park) position.

2. Keep the foot brake pedal depressed and move the shift selector into a driving gear.

3. Release the foot brake, then gradually start the vehicle in motion.

4. Stop the vehicle completely before shifting the shift selector to the P (Park) position.

The CVT is designed so the foot brake pedal MUST be depressed before shifting from P (Park) to any drive position while the ignition switch is in the ON position.

The shift selector cannot be moved out of P (Park) and into any of the other gear positions if the ignition switch is turned to the LOCK or OFF position or if the key is removed.

To move the shift selector.

To move the shift selector.

the brake pedal Push the button A while depressing the brake pedal Shift without pushing button A Push the button A to shift Shifting Shift without pushing button A

    See also:

    Training procedure
    The procedure for training a voice is as follows. 1. Position the vehicle in a reasonably quiet outdoor location. 2. Sit in the driver’s seat with the engine running, the parking brake on, and ...

    Wheels and tires
    If you have a flat tire, see “Flat tire” in the “In case of emergency” section of this manual. ...

    Receiving a call
    When you hear the ring tone, press the button on the steering wheel. Once the call has ended, press the button on the steering wheel. NOTE: If you do not wish to take the call when you ...