Cruise control operations

The cruise control allows driving at a speed between 25 - 89 MPH (40 - 144 km/h) without keeping your foot on the accelerator pedal.

To turn on the cruise control, push the ON·OFF switch. The CRUISE indicator light in the instrument panel comes on.

To set cruising speed, accelerate the vehicle to the desired speed, push the COAST/SET switch and release it. The SET indicator light in the instrument panel comes on. Take your foot off the accelerator pedal. Your vehicle maintains the set speed.

To pass another vehicle, depress the accelerator pedal. When you release the pedal, the vehicle returns to the previously set speed.

● The vehicle may not maintain the set speed when going up or down steep hills. If this happens, drive without the cruise control.

To cancel the preset speed, use one of the following three methods.

● Push the CANCEL button; the SET indicator light in the instrument panel goes out.

● Tap the brake pedal; the SET indicator light goes out.

● Push the ON·OFF switch off. Both the CRUISE indicator light and SET indicator light in the instrument panel go out.

The cruise control is automatically canceled and the SET light in the instrument panel goes out if.

● you depress the brake or clutch pedal while pushing the ACCEL/RES or SET/COAST switch. The preset speed is deleted from memory.

● the vehicle slows down more than 8 MPH (13 km/h) below the set speed.

● you depress the clutch pedal (manual transmission), or move the shift selector to N (Neutral) (CVT).

To reset at a faster cruising speed, use one of the following three methods.

● Depress the accelerator pedal. When the vehicle attains the desired speed, push and release the COAST/SET switch.

● Push and hold the ACCEL/RES switch.

When the vehicle attains the speed you desire, release the switch.

● Push and release the ACCEL/RES switch.

Each time you do this, the set speed increases by about 1 MPH (1.6 km/h).

To reset at a slower cruising speed, use one of the following three methods.

● Lightly tap the brake pedal. When the vehicle attains the desired speed, push the COAST/SET switch and release it.

● Push and hold the COAST/SET switch. Release the switch when the vehicle slows to the desired speed.

● Push and release the COAST/SET switch.

Each time you do this, the set speed decreases by about 1 MPH (1.6 km/h).

To resume the preset speed, push and release the ACCEL/RES switch. The vehicle returns to the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h).

    See also:

    Battery
    If the battery is not fully charged during extremely cold weather conditions, the battery fluid may freeze and damage the battery. To maintain maximum efficiency, the battery should be checked reg ...

    Silencing the horn beep feature
    If desired, the horn beep feature can be deactivated using the Intelligent Key. To deactivate: Press and hold the and buttons for at least 2 seconds. The hazard warning lights will flash 3 tim ...

    2011 Nissan Sentra review
    Some cars get all the attention, and the Nissan Sentra isn't one of them. Its name isn't always uttered in the same sentences as models like the Honda Civic and Toyota Corolla, but after driving o ...