To protect your vehicle from corrosion
● Wash and wax your vehicle often to keep the vehicle clean.
● Always check for minor damage to the paint and repair it as soon as possible.
● Keep drain holes at the bottom of the doors open to avoid water accumulation.
● Check the underbody for accumulation of sand, dirt or salt. If present, wash with water as soon as possible.

● NEVER remove dirt, sand or other debris from the passenger compartment by washing it out with a hose. Remove dirt with a vacuum cleaner or broom.
● Never allow water or other liquids to come in contact with electronic components inside the vehicle as this may damage them.
Chemicals used for road surface de-icing are extremely corrosive. They accelerate corrosion and deterioration of underbody components such as the exhaust system, fuel and brake lines, brake cables, floor pan and fenders.
In winter, the underbody must be cleaned periodically.
For additional protection against rust and corrosion, which may be required in some areas, consult a NISSAN dealer.
See also:
Removing wheel cover (if so equipped)
Never use your hands to remove the
wheel cover. This may cause personal
injury.
To remove the wheel cover, use the jack rod 1
as illustrated.
Apply cloth 2 between the wheel and jack rod ...
Loading tips
- The GVW must not exceed GVWR or
GAWR as specified on the F.M.V.S.S./
C.M.V.S.S. certification label.
- Do not load the front and rear axle to
the GAWR. Doing so will exceed the
GVWR.
- ...
Engine block heater (if so equipped)
WARNING:
- Do not use your engine block heater
with an ungrounded electrical system
or a 2-pronged adapter. You can be seriously
injured by an electrical shock if
you use an ungrounded connec ...
