Air cleaner

MR20DE
MR20DE

The air cleaner filter should not be cleaned and reused. Replace it according to the maintenance log shown in the “NISSAN Service and Maintenance Guide.” To remove the air cleaner filter.

1. Unlatch the clips and move the air cleaner cover upward.

2. Remove the air cleaner filter.

● For the MR20DE, release the 2 retaining clips A and pull the unit upward.

● For the QR25DE, push the tabs A and pull the unit upward B .

QR25DE
QR25DE

3. Wipe the inside of the air cleaner filter housing and the cover with a damp cloth.

NOTE:
After installing a new air cleaner, make sure the air cleaner cover is seated in the housing and latch the clips.

● Operating the engine with the air
● Operating the engine with the air cleaner removed can cause you or others to be burned. The air cleaner not only cleans the air, it stops the flame if the engine backfires. If it isn’t there, and the engine backfires, you could be burned. Do not drive with the air cleaner removed, and be careful when working on the engine with the air cleaner removed.

● Never pour fuel into the throttle body or attempt to start the engine with the air cleaner removed. Doing so could result in serious injury.

See also:

Changing a flat tire
If you have a flat tire, follow the instructions below: ...

Read first — then drive safely
Before driving your vehicle, read your Owner’s Manual carefully. This will ensure familiarity with controls and maintenance requirements, assisting you in the safe operation of your vehicle. ...

USB interface (models without Navigation System) (if so equipped)
Connecting a device to the USB input jack The USB input jack is located in the center console. Open the protective cover (1) on the USB jack, then insert the USB device into the jack. When a ...