Headlights

Replacing the halogen headlight bulb

The headlight is a semi-sealed beam type which uses a replaceable headlight (halogen) bulb. Because the headlight assembly must be removed from the vehicle for bulb replacement, see your NISSAN dealer.

● Aiming is not necessary after replacing

● Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer.

● Do not leave the headlight assembly open without a bulb installed for a long period of time. Dust, moisture, smoke, etc. entering the headlight body may affect bulb performance. Remove the bulb from the headlight assembly just before a replacement bulb is installed.

● Only touch the base when handling the bulb. Never touch the glass envelope.

Touching the glass could significantly affect bulb life and/or headlight performance.

● High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.

● Use the same number and wattage as shown in the chart.

Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer.

    See also:

    2009 Nissan Maxima review
    As a consumer, I've never considered buying a Nissan Maxima. It just hasn't been on my car radar. After test-driving a 2009 Maxima for a week, it's now on my radar. In fact, I give it the maximum ...

    Clearing the programmed information
    Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). ...

    Glove box
    Glove box Open the glove box by pulling the handle. Keep glove box lid closed while driving to help prevent injury in an accident or a sudden stop. ...