LATCH lower anchor
Failure to follow the warnings and
instructions for proper use and installation
of child restraints could result in
serious injury or death of a child or
other passengers in a sudden stop or
collision:
- Attach LATCH system compatible
child restraints only at the locations
shown in the illustration.
- Do not secure a child restraint in the center rear seating position using the LATCH lower anchors. The child restraint will not be secured properly.
- Inspect the lower anchors by inserting your fingers into the lower anchor area. Feel to make sure there are no obstructions over the anchors such as seat belt webbing or seat cushion material. The child restraint will not be secured properly if the lower anchors are obstructed.
See also:
Headlight beam select
Headlight beam select
1 To select the low beam, put the lever in the neutral
position as shown.
2 To select the high beam, push the lever forward
while the switch is in the position. Pull it ...
Readiness for Inspection/Maintenance (I/M) test
A vehicle equipped with All-Wheel Drive (AWD)
should never be tested using a two wheel
dynamometer (such as the dynamometers used
by some states for emissions testing), or similar
equipment. M ...
Forward-facing child restraint installation using latch
Refer to all Warnings and Cautions in the Child
Safety and Child Restraint sections before installing
a child restraint.
Follow these steps to install a forward-facing
child restraint using the ...