Auto-reverse function (if so equipped)

There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window.
If the control unit detects something caught in the window as it is closing, the window will be immediately lowered.
The auto reverse function can be activated when the window is closed by automatic operation when the ignition switch is in the ON position or for 45 seconds after the ignition switch is turned to the OFF position.
Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the window occurs.
See also:
Maximum load limits
Maximum trailer loads
Never allow the total trailer load to exceed the
value specified in the Towing
Load/Specification chart found later in this section.
The total trailer load equals trailer w ...
Blocking wheels
Place suitable blocks 1 at both the front and
back of the wheel diagonally opposite the flat tire
2 to prevent the vehicle from moving when it is
jacked up.
WARNING
Be sure to block the wheel a ...
Operations after activation
- When the rear view is displayed on the left
side on the screen (B or C ), the view on
the right side switches between the
bird’seye view B and the front-side view
C each time the CAMERA bu ...
