Automatic moonroof

The moonroof only operates when the ignition switch is in the ON position.

The automatic moonroof is operational for about 45 seconds, even if the ignition switch is turned to the OFF position. If the driver’s door or the passenger’s door is opened during this period of about 45 seconds, power to the moonroof is canceled.

Sunshade

The sunshade will open automatically when the moonroof is opened. However, it must be closed manually.

Sliding the moonroof

Sliding the moonroof

To fully open or close the moonroof, push the switch toward 2 and release 1 or 2 and release 2 and release it; it need not be held. The roof will automatically open or close all the way. To stop the roof, push the switch in any direction while it is opening or closing.

Tilting the moonroof

To tilt up, first close the moonroof by pushing the switch toward 2 again and 2 . Push the switch toward release it; it need not be 2 again and release it; it need not be held. To tilt down the moonroof, push the switch toward Auto reverse function 1 .

Auto reverse function

There are some small distances immediately

There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof.

If the control unit detects something caught in the moonroof when it is closing, the moonroof will be immediately opened.

The auto reverse function can be activated when the moonroof is closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is turned to the OFF position.

If the moonroof cannot be closed automatically when the auto reverse function activates due to a malfunction, push and hold the switch toward Depending on the environment or driving 2 .

Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs.

If the moonroof does not operate

If the moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system.

1. If the moonroof is open, close it fully by repeatedly pushing the switch toward 2 .
2 .

2. Push and hold the switch toward tilt the moonroof up. 2 to tilt the moonroof up.

3. Release the moonroof switch after the moonroof moves slightly up and down.

4. Push and hold the switch toward 1 to
1 to fully tilt the moonroof down.

5. Check if the moonroof switch operates normally.

If the moonroof does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer.

    See also:

    Connecting procedure
    NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. 1. Press the button on t ...

    INTERIOR
    As fun as the exterior of the Juke is, it's only the beginning. The interior has just as good a time. It's utilitarian but full of technological features. My favorite feature in the five-seater i ...

    Master warning light
    When the ignition is in the ON position, the master warning light illuminates if any of the following are displayed on the vehicle information display. ● No key warning ● Low fuel w ...