Programming trouble-diagnosis

If HomeLink® does not quickly learn the handheld transmitter information:
- replace the hand-held transmitter batteries with new batteries.

- position the hand-held transmitter with its battery area facing away from the HomeLink® surface.

- push and hold both the HomeLink® and hand-held transmitter buttons without interruption.

- position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink® is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times.

If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this Owner’s Manual.

    See also:

    Key operation (if so equipped)
    Key operation (if so equipped) To open the trunk lid, turn the key clockwise. To close the trunk lid, lower and push the trunk lid down securely. ...

    Engine block heater (if so equipped)
    Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine block h ...

    FM-AM-SAT(if so equipped) radio operation
    radio (FM/AM) band select: Pushing the radio band select button will change the band as follows: AM FM1 FM2 AM radio (SAT) band select (models with satellite radio): Pushing the XM b ...