RearView monitor (if so equipped)

When the selector lever is shifted into the R (Reverse) position, the monitor display shows the view to the rear of the vehicle.

The system is designed as an aid to the driver in detecting large stationary objects to help avoid damaging the vehicle. The system will not detect small objects below the bumper and may not detect objects close to the bumper or on the ground.

- The rear view camera is a convenience

- The rear view camera is a convenience but it is not a substitute for proper backing up. Always turn and check that it is safe to do so before backing up. Always back up slowly.

- Objects viewed in the RearView Monitor differ from actual distance because a wide-angle lens is used.

Objects in the RearView Monitor will appear visually opposite than when viewed in the rear view and outside mirrors.

- Make sure that the lift gate is securely closed when backing up.

- Underneath the bumper and the corner areas of the bumper cannot be viewed on the RearView Monitor because of its monitoring range limitation.

- Do not put anything on the rear view camera.

- When washing the vehicle with high-pressure water, be sure not to spray it around the camera. Otherwise, water may enter the camera unit causing water condensation on the lens, a malfunction, fire or an electric shock.

- Do not strike the camera. It is a precision instrument. Otherwise, it may malfunction or cause damage resulting in a fire or an electric shock.

Do not scratch the camera lens when

Do not scratch the camera lens when cleaning dirt or snow from the lens.

See also:

Loose Fuel Cap warning message
Loose Fuel Cap warning message The LOOSE FUEL CAP warning message displays in the odometer when the fuel-filler cap is not tightened correctly after the vehicle has been refueled. It may take ...

Injured persons
NISSAN recommends that injured persons use seat belts. Check with your doctor for specific recommendations. ...

Getting the spare tire and tools
Sedan Coupe Sedan Open the trunk. Lift the trunk floor carpeting and spare tire cover. Remove the jack 1 and wheel nut wrench 2 from the tool box. Turn the clamp to remove the spare tire ...