Manual command selection
Commands can be selected manually. While the
commands are displayed on the audio screen,
select a command by operating the audio tuning
switch, and then push the 
switch.
Once a
command is manually selected, the voice
command function is cancelled. To return to
voice command mode, push the 
switch
to
cancel the current operation, and then perform
the first procedure of voice command.
See also:
Programming HomeLink
1. To begin, press and hold the two outer
HomeLink buttons (to clear the memory)
until the indicator light 1 blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held ...
Radio
Place the ignition switch in the ACC or ON
position and press the POWER/VOLUME control
knob to turn the radio on. If you listen to the
radio with the engine not running, the ignition
switch sh ...
Programming trouble-diagnosis
If the HomeLink does not quickly learn the handheld
transmitter information:
● replace the hand-held transmitter batteries
with new batteries.
● position the hand-held transmitter with ...