Jump starting
To start your engine with a booster battery, the instructions and precautions below must be followed.
- If done incorrectly, jump starting can lead to a battery explosion, resulting in severe injury or death.
It could also damage your vehicle.
- Explosive hydrogen gas is always present in the vicinity of the battery.
Keep all sparks and flames away from the battery.
- Do not allow battery fluid to come into contact with eyes, skin, clothing or painted surfaces. Battery fluid is a corrosive sulfuric acid solution which can cause severe burns. If the fluid should come into contact with anything, immediately flush the contacted area with water.
- Keep the battery out of the reach of children.
- The booster battery must be rated at 12 volts. Use of an improperly rated battery can damage your vehicle.
- Whenever working on or near a battery, always wear suitable eye protectors (for example, goggles or industrial safety spectacles) and remove rings, metal bands, or any other jewelry. Do not lean over the battery when jump starting.
- Do not attempt to jump start a frozen battery. It could explode and cause serious injury.
- Your vehicle has an automatic engine cooling fan. It could come on at any time. Keep hands and other objects away from it.
Always follow the instructions below.
Failure to do so could result in damage to the charging system and cause personal injury.
1. If the booster battery is in another vehicle B , position the two vehicles (A and B ) to bring their batteries into close proximity to each other.
Do not allow the two vehicles to touch.
2. Apply the parking brake. Move the selector lever to the P (Park) position. Switch off all unnecessary electrical systems (lights, heater, air conditioner, etc.).
3. Remove vent caps on the battery (if so equipped). Cover the battery with a firmly wrung out moist cloth to reduce explosion hazard.
4. Connect jumper cables in the sequence as
illustrated (1 2
3
4 ).
For the vehicle equipped with Intelligent
Key system:
If the battery is discharged, the ignition
switch cannot be moved from the LOCK
position. Connect the jumper cables to
the booster vehicle B before turning
the ignition switch.
- Always connect positive (+) to positive (+) and negative (−) to body ground (for example, as illustrated), not to the battery.
- Make sure the jumper cables do not touch moving parts in the engine compartment and that the cable clamps do not contact any other metal.
5. Start the engine of the booster vehicle B and let it run for a few minutes.
6. Keep the engine speed of the booster vehicle B at about 2,000 rpm, and start the engine of the vehicle A being jump started.
Do not keep the starter motor engaged for more than 10 seconds. If the engine does not start right away, turn the ignition switch to the OFF position and wait 10 seconds before trying again.
7. After starting your engine, carefully disconnect
the negative cable and then the positive
cable (4 3
2
1 ).
8. Replace the vent caps (if so equipped). Be sure to dispose of the cloth used to cover the vent holes as it may be contaminated with corrosive acid.
See also:
Vehicle Overview
The Nissan Frontier received a mid-cycle freshening for 2009. The minor
face-lift will help distinguish the Frontier from the 2009 Suzuki Equator, which
Nissan will build for Suzuki and which is b ...
Operations after activation
- When the rear view is displayed on the left
side on the screen (B or C ), the view on
the right side switches between the
bird’seye view B and the front-side view
C each time the CAMERA bu ...
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not
allow the engine to start without the use of the
registered key.
If the engine fails to start using a registered key
(for example, when interferen ...