Vehicle set-up
1. Park the vehicle on a level surface and apply the parking brake.
2. Start the engine and let it idle until it reaches operating temperature.
3. Turn the engine off and wait more than 10 minutes.
4. Raise and support the vehicle using a suitable floor jack and safety jack stands.
- Place the safety jack stands under the vehicle jack-up points.
- A suitable adapter should be attached to the jack stand saddle.
Make sure the correct lifting and support points are used to avoid vehicle damage.
See also:
iPod Player Operation with Navigation System (if so equipped)
Connecting iPodT
To connect an iPodT to the vehicle so that the
iPodT can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console. Open ...
Off-road recovery
If the right side or left side wheels leave the road
surface, maintain control of the vehicle by
following the procedure below. Please note that
this procedure is only a general guide. The
veh ...
Steering wheel switch for audio control (if so
equipped)
Steering wheel switch for audio control (if so
equipped)
1. Tuning switch
2. VOLUME control switch
3. SOURCE select switch ...