Intelligent Key battery

Replace the battery in the Intelligent Key as

Replace the battery in the Intelligent Key as follows:
1. Remove the mechanical key from the Intelligent Key.

2. Insert a small screwdriver into the slit of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.

3. Replace the battery with a new one.

Recommended battery:
CR2025 or equivalent
- Do not touch the internal circuit and electric terminals as doing so could cause a malfunction.

- Hold the battery by the edges. Holding the battery across the contact points will seriously deplete the storage capacity.

- Make sure that the + side faces the bottom case.

4. Align the tips of the upper and lower parts

4. Align the tips of the upper and lower parts 1 , and then push them together 2 until it is securely closed.

5. Operate the buttons to check its operation.

See a NISSAN dealer if you need any assistance for replacement.

FCC Notice:

For USA:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For Canada:
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

    See also:

    NISSAN Vehicle Immobilizer System
    The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of the registered key. If the engine fails to start using the registered key, it may be due to interfere ...

    Daytime running light system (Canada only)
    The daytime running lights automatically illuminate when the engine is started with the parking brake released. The daytime running lights operate with the headlight switch in the OFF position ...

    Removing the bolt-on wheel cover (if so equipped)
    CAUTION Do not use your hands to pry off wheel caps or wheel covers. Doing so could result in personal injury. The wheel covers are held on by the wheel nuts. The wheel cover will be removed al ...