Class I hitch

Class I trailer hitch equipment (receiver, ball mount and hitch ball) can be used to tow trailers of a maximum weight of 2,000 lb (909 kg).

- The hitch should not be attached to

- The hitch should not be attached to or affect the operation of the impact- absorbing bumper.

- Do not use axle-mounted hitches.

- Do not modify the vehicle exhaust system, brake system, etc. to install a trailer hitch.

- To reduce the possibility of additional damage if your vehicle is struck from the rear, where practical, remove the hitch and/or receiver when not in use. After the hitch is removed, seal the bolt holes to prevent exhaust fumes, water or dust from entering the passenger compartment.

- Regularly check that all trailer hitch mounting bolts are securely mounted.

    See also:

    Indicator lights
    Continuously Variable Transmission (CVT) indicator light When the ignition switch is placed in the ON position, the light comes on for 2 seconds. Continuously Variable Transmission ( ...

    Continuously Variable Transmission (CVT) fluid
    - Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluids. - Using transmission fluid other than Genuine NISSAN CVT Fluid NS-2 will damage the CVT, which is not covered by th ...

    Training phrases
    During the SA mode, the system instructs the trainer to say the following phrases. (The system will prompt you for each phrase.) ● phonebook transfer entry ● dial three oh four two nin ...