Safety chains

Always use a suitable chain between your vehicle and the trailer. The safety chains should be crossed and should be attached to the hitch, not to the vehicle bumper or axle. The safety chains can be attached to the bumper if the hitch ball is mounted to the bumper. Be sure to leave enough slack in the chains to permit turning corners.

    See also:

    F.M.V.S.S./C.M.V.S.S. certification label
    The Federal/Canadian Motor Vehicle Safety Standards (F.M.V.S.S./C.M.V.S.S.) certification label is affixed as shown. This label contains valuable vehicle information, such as: Gross Vehicle ...

    RearView Monitor (if so equipped)
    When the shift selector is shifted into the R (Reverse) position, the monitor display shows a rearward view from the vehicle. ● The system is designed as an aid to the driver in detec ...

    Warning for low battery power
    When the Intelligent Key battery is low, the Intelligent Key system warning light ( ) will blink green for about 30 seconds after the ignition switch is placed in the ON position. This warning ...