Booster seats

Precautions on booster seats

WARNING:

If a booster seat and seat belt are not used properly, the risk of a child being injured in a sudden stop or collision greatly increases:

Make sure the shoulder portion of the belt is away from the childs face and neck and the lap portion of the belt does not cross the stomach.

Make sure the shoulder belt is not behind the child or under the childs arm.

A booster seat must only be installed in a seating position that has a lap/shoulder belt.

Booster seats of various sizes are offered by

Booster seats of various sizes are offered by several manufacturers. When selecting any booster seat, keep the following points in mind:

- Choose only a booster seat with a label certifying that it complies with Federal Motor Vehicle Safety Standard 213 or Canadian Motor Vehicle Safety Standard 213.

- Check the booster seat in your vehicle to be sure it is compatible with the vehicles seat and seat belt system.

-Make sure the childs head will be properly

-Make sure the childs head will be properly supported by the booster seat or vehicle seat. The seatback must be at or above the center of the childs ears. For example, if a low back booster seat s is chosen, the vehicle seatback must be at or above the center of the childs ears. If the seatback is lower than the center of the childs ears, a high back booster seats should be used.

- If the booster seat is compatible with your vehicle, place the child in the booster seat and check the various adjustments to be sure the booster seat is compatible with the child. Always follow all recommended procedures.

All U.S. states and Canadian provinces or

All U.S. states and Canadian provinces or territories require that infants and small children be restrained in an approved child restraint at all times while the vehicle is being operated.

The instructions in this section apply to booster seat installation in the rear seats or the front passenger seat.

Booster seat installation

CAUTION:

Do not use the lap/shoulder belt in the Automatic Locking Retractor mode when using a booster seat with the seat belts.

Refer to all Warnings and Cautions in the Child Safety, Child Restraint and Booster Seats sections before installing a child restraint.

Follow these steps to install a booster seat in the rear seat or in the front passenger seat:

1. If you must install a booster seat in the

1. If you must install a booster seat in the front seat, move the seat to the rearmost position.

2. Position the booster seat on the seat. Only place it in a front-facing direction. Always follow the booster seat manufacturers instructions.

Front passenger position
Front passenger position

3. The booster seat should be positioned on the vehicle seat so that it is stable.

If necessary, adjust or remove the head restraint or headrest to obtain the correct booster seat fit. If the head restraint or headrest is removed, store it in a secure place. Be sure to reinstall the head restraint or headrest when the booster seat is removed.

See Head restraints or Adjustable headrests in this section for head restraint or headrest adjustment, removal and installation information.

If the seating position does not have an adjustable head restraint or headrest and it is interfering with the proper booster seat fit, try another seating position or a different booster seat.

4. Position the lap portion of the seat belt low and snug on the childs hips. Be sure to follow the booster seat manufacturers instructions for adjusting the seat belt routing.

5. Pull the shoulder belt portion of the seat belt toward the retractor to take up extra slack.

Be sure the shoulder belt is positioned across the top, middle portion of the childs shoulder. Be sure to follow the booster seat manufacturers instructions for adjusting the seat belt routing.

6. Follow the warnings, cautions and instructions for properly fastening a seat belt shown in Three-point type seat belt with retractor earlier in this section.

7. If the booster seat is installed in the front

7. If the booster seat is installed in the front passenger seat, place the ignition switch in the ON position. The front passenger air bag status light may or may not illuminate, depending on the size of the child and the type of booster seat being used. See Front passenger air bag and status light later in this section.

    See also:

    Getting started
    The following procedures will help you get started using the Bluetooth Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to “List of voice commands” ...

    Tire pressures
    - When towing a trailer, inflate the vehicle tires to the recommended cold tire pressure indicated on the Tire and Loading Information label. - Trailer tire condition, size, load rating and p ...

    NISSAN vehicle immobilizer system
    The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interference ...