Climate control seat switch (if so equipped)

The climate controlled seat warms up or cools

The climate controlled seat warms up or cools down the front seat by blowing warm or cool air from the surface of the seat. The climate control switch is located on the center console.

The climate controlled seat can be operated as follows:

1. Start the engine.

2. Turn the control knob to the H (Heat) side or to the C (Cool) side, as desired. The indicator light on the control knob will illuminate.

3. Adjust the desired amount of air using the control knob. The climate controlled seat blower remains on low speed for approximately 60 seconds after turning the switch on or selecting the desired temperature.

4. When the vehicles interior is warmed or cooled, or before you leave the vehicle, be sure to turn the control knob to the Off (center) position To check the air filter for the climate controlled seat, contact a NISSAN dealer.

CAUTION:

- The battery could run down if the climate control seat is operated while the engine is not running.

- Do not use the climate control seat for extended periods or when no one is using the seat.

- Do not put anything on the seat which insulates heat, such as a blanket, cushion, seat cover, etc. Otherwise, the seat may become overheated.

- Do not place anything hard or heavy on the seat or pierce it with a pin or similar objects. This may result in damage to the climate controlled seat.

- Any liquid spilled on the seat should be removed immediately with a dry cloth - The climate controlled seat has an air filter. Do not operate the climate controlled seat without an air filter. This may result in damage to the system.

- When cleaning the seat, never use gasoline, benzine, thinner, or any similar materials.

- If any malfunctions are found or the climate controlled seat does not operate, turn the switch off and have the system checked by your NISSAN dealer.

    See also:

    Lift gate release
    Lift gate release If the lift gate cannot be opened due to a discharged battery, follow these steps. 1. Remove the cover inside of the lift gate with a suitable tool. 2. Move the lever toward ...

    Programming HomeLink®
    To program your HomeLink® Transceiver to operate a garage door, gate, or entry door opener, home or office lighting, you need to be at the same location as the device. Note: Garage door opene ...

    High Points
    Though it has cheaper rear drum brakes — the norm for this class — the Versa stops confidently, with strong, linear pedal feel. Ride comfort is another plus. The last Versa was a soft car, and ...