Programming HomeLink for Canadian customers
Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds.
To program your hand-held transmitter to HomeLink, continue to press and hold the HomeLink button (see steps 2 - 4 under Programming HomeLink) while you press and repress (cycle) your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
When programming a garage door opener, etc., it is advised to unplug the device during the cycling process to prevent possible damage to the garage door opener components.
See also:
Antenna
Antenna
To remove the antenna, hold the bottom of the
antenna and turn it counterclockwise.
To install the antenna, turn the antenna clockwise
and tighten.
- To avoid damaging or deformin ...
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of a
registered key.
If the engine fails to start using a registered key
(for example, when interference ...
Gasoline specifications
NISSAN recommends using gasoline that meets
the World-Wide Fuel Charter (WWFC) specifications
where it is available. Many of the
automobile manufacturers developed this specification
to improv ...