Programming trouble-diagnosis

If the HomeLink does not quickly learn the handheld transmitter information:

- replace the hand-held transmitter batteries with new batteries.

- position the hand-held transmitter with its battery area facing away from the HomeLink surface.

- press and hold both the HomeLink and hand-held transmitter buttons without interruption.

- position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position keeping the indicator light in view at all times.

If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual.

    See also:

    Battery
    ● Keep the battery surface clean and dry. Clean the battery with a solution of baking soda and water. ● Make certain the terminal connections are clean and securely tightened. χ ...

    Tilt operation
    Tilt operation Pull the lock lever down 1 and adjust the steering wheel up or down 2 to the desired position. Push the lock lever up 3 securely to lock the steering wheel in place. A clickin ...

    Heated seat (if so equipped)
    The front seats are warmed by built-in heaters. 1. Start the engine. 2. Push the low or high position of the switch, as desired, depending on the temperature. The indicator light in the switch w ...