Hood

(1) Pull the hood lock release handle located

(1) Pull the hood lock release handle located below the driver side instrument panel. The hood will spring up slightly.

 (2)- Push the lever at the front of the hood to the side as illustrated with your fingertips and raise the hood.

When closing the hood, lower it slowly and make sure it locks into place.

WARNING:

- Make sure the hood is completely closed and latched before driving. Failure to do so could cause the hood to fly open and result in an accident.

- If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.

    See also:

    Installing front license plate
    Use the following steps to mount the front license plate: (1) Make holes on the plastic finisher at the location mark (small dimple) using a 0.31 in (8 mm) drill. Apply light pressure to the ...

    Vehicle security system activation
    The vehicle security system will give the following alarm: ● The headlights blink and the horn sounds intermittently. ● The alarm automatically turns off after approximately 50 second ...

    INTERIOR
    The interior of the Pathfinder was where I had most of my problems. I may have even used an inappropriate word or two in frustration. My problem was I couldn't figure out how to use most of the sy ...