NISSAN Intelligent key battery discharge

If the battery of the Intelligent Key is almost discharged,

If the battery of the Intelligent Key is almost discharged, the guide light (A) of the Intelligent Key port blinks and the indicator appears on the vehicle information display. See Vehicle information display in the Instruments and controls section.

In this case, inserting the Intelligent Key into the port (B)- allows you to start the engine. Make sure the Intelligent Key is placed in the correct direction:

The front side faces upward and the key ring side faces downward as illustrated.

To remove the Intelligent Key from the port, push

To remove the Intelligent Key from the port, push the ignition switch to the LOCK position and pull the Intelligent Key out of the port (C).

NOTE:

The Intelligent Key port does not charge the Intelligent Key battery. If you see the low battery indicator, replace the battery as soon as possible. See Battery replacement in the Maintenance and do-ityourself section.

CAUTION:

- Never place anything except the Intelligent Key in the Intelligent Key port. Doing so may cause damage to the equipment.

- Make sure the Intelligent Key is in the correct direction when inserting it to the Intelligent Key port. The engine may not start if it is in the wrong direction.

- Remove the Intelligent Key from the Intelligent Key port after the ignition switch is pushed to the LOCK position.

    See also:

    Explanation of general maintenance items
    Additional information on the following items with “ * ”is found later in this section. Outside the vehicle The maintenance items listed here should be performed from time to time, unless othe ...

    NISSAN dealer.
    However, now and then you may notice light spark knock for a short time while accelerating or driving up hills. This is not a cause for concern, because you get the greatest fuel benefit when ther ...

    Choosing a language
    You can interact with the Bluetooth Hands-Free Phone System using English, Spanish or French. To change the language, perform the following. 1. Press and hold the button for more than 5 seconds ...