Engine block heater (if so equipped)

WARNING:

- Do not use your engine block heater with an ungrounded electrical system or a 2-pronged adapter. You can be seriously injured by an electrical shock if you use an ungrounded connection.

- Disconnect and properly store the engine block heater cord before starting the engine. Damage to the cord could result in an electrical shock and can cause serious injury.

- Use a heavy-duty 3-wire, 3-pronged extension cord rated for at least 10 A. Plug the extension cord into a Ground Fault Interrupt (GFI) protected, grounded 110-VAC outlet. Failure to use the proper extension cord or a grounded outlet can result in a fire or electrical shock and cause serious personal injury.

Engine block heaters are available through NISSAN dealers to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 20° F (-7° C) or lower.

To use the engine block heater:

1. Turn the engine off.

2. Open the hood and unwrap the engine block heater cord.

3. Plug the engine block heater cord into a grounded 3 wire, 3 pronged extension cord.

4. Plug the extension cord into a Ground Fault Interrupt (GFI) protected, grounded 110- volt AC (VAC) outlet.

5. The engine block heater must be plugged in for at least 2 - 4 hours, depending on outside temperatures, to properly warm the engine coolant. Use an appropriate timer to turn the engine block heater on.

6. Before starting the engine, unplug and properly store the cord to keep it away from moving parts.

    See also:

    Slip indicator light
    This indicator will blink when the VDC system or the traction control system is operating, thus alerting that the vehicle is nearing its traction limits. The road surface may be slippery. ...

    Changing engine oil
    MR20DE engine A Oil filler cap B Oil drain plug C Oil filter QR25DE engine A Oil filler cap B Oil drain plug C Oil filter 1. Park the vehicle on a level surface and apply the parking ...

    Sun visors
    Coupe shown, sedan similar 1 To block glare from the front, swing down the main sun visor. 2 To block glare from the side, remove the sun visor from the center mount and swing the sun visor to ...