Battery

-Keep the battery surface clean and dry.

Clean the battery with a solution of baking soda and water.

- Make certain the terminal connections are clean and securely tightened.

- If the vehicle is not to be used for 30 days or longer, disconnect the negative (-) battery terminal cable to prevent discharge.

WARNING:

- Do not expose the battery to flames, an electrical spark or a cigarette. Hydrogen gas generated by the battery is explosive.

Explosive gases can cause blindness or injury. Do not allow battery fluid to contact your skin, eyes, fabrics or painted surfaces. Sulfuric acid can cause blindness or injury. After touching a battery or battery cap, do not touch or rub your eyes. Thoroughly wash your hands. If the acid contacts your eyes, skin or clothing, immediately flush with water for at least 15 minutes and seek medical attention.

- Do not operate the vehicle if the fluid in the battery is low. Low battery fluid can cause a higher load on the battery which can generate heat, reduce battery life, and in some cases lead to an explosion.

- When working on or near a battery, always wear suitable eye protection and remove all jewelry.

- Battery posts, terminals and related accessories contain lead and lead compounds.

Wash hands after handling.

- Keep battery out of the reach of children.

- Do not tip the battery. Keep the vent caps tight and the battery level.

1. Remove the vent caps with a screwdriver as

1. Remove the vent caps with a screwdriver as shown. Use a cloth to protect the battery case.

2. Check the fluid level in each cell. If it is

2. Check the fluid level in each cell. If it is necessary to add fluid, add only distilled water to bring the level up to the bottom of the filler opening. Do not overfill. . Reinstall the vent caps.

Vehicles operated in high temperatures or under severe conditions require frequent checks of the battery fluid level.

    See also:

    Adjusting the screen (models with Navigation System)
    Adjusting the screen (models with Navigation System) To adjust the quality of the screen, perform the following. 1. Press the SETUP button. 2. Touch “System”. 3. Touch “Display”. 4. ...

    Switch operation
    Switch operation The windshield wiper and washer operates when the ignition switch is placed in the ON position. Push the lever down to operate the wiper at the following speed: 1 Intermit ...

    Headlight beam select
    1 To select the high beam function, push the lever forward. The high beam lights come on and the light illuminates. 2 Pull the lever back to select the low beam. 3 Pulling and releasing the lev ...