Drive belt

1. Power steering fluid pump.

1. Power steering fluid pump.

2. Generator.

3. Air conditioner compressor.

4. Crankshaft pulley.

WARNING:

Be sure the ignition switch is in the OFF or LOCK position before servicing drive belt.

The engine could rotate unexpectedly.

1. Visually inspect the belt for signs of unusual wear, cuts, fraying or looseness. If the belt is in poor condition or is loose, have it replaced or adjusted by a NISSAN dealer.

2. Have the belt checked regularly for condition and tension in accordance with the maintenance schedule found in the NISSAN Service and Maintenance Guide.

    See also:

    In-cabin microfilter
    The in-cabin microfilter restricts the entry of airborne dust and pollen particles and reduces some objectionable outside odors. The filter is located behind the trim panel near the accelerator ...

    Battery saver system
    If the ignition switch is placed in the OFF position while the headlight switch is in the or position, the headlights will turn off after 5 minutes. CAUTION Even though the battery saver feat ...

    Locking with key
    The power door lock system allows you to lock or unlock all doors at the same time. Turning the key toward the front 1 of the vehicle locks all doors. Turning the key one time toward the rear 2 ...