Shoulder belt height adjustment (Sedan, front seats)
The shoulder belt anchor height should be adjusted to the position best for you. See “Precautions on seat belt usage” earlier in this section. To adjust, pull out the adjustment button 1 and move the shoulder belt anchor to the desired position 2 , so the belt passes over the center of the shoulder. The belt should be away from your face and neck, but not falling off your shoulder. Release the adjustment button to lock the shoulder belt anchor into position.
WARNING
● After adjustment, release the adjustment button and try to move the shoulder belt anchor up and down to make sure it is securely fixed in position.
● The shoulder belt anchor height should be adjusted to the position best for you. Failure to do so may reduce the effectiveness of the entire restraint system and increase the chance or severity of injury in an accident.
See also:
Exterior design
First revealed as the Qazana show car - unveiled at the 2009 Geneva Motor
Show - Juke was created at the London-based Nissan Design Europe and refined at
Nissan's Design Centre (NDC) in Japan. Qas ...
Sun visors
Sun visors
1. To block out glare from the front, swing
down the sun visor 1 .
2. To block glare from the side, remove the sun
visor from the center mount and swing it to
the side 2 . ...
Clearing the programmed information
Individual buttons cannot be cleared. However,
to clear all programming, press and hold the two
outside buttons and release when the indicator
light begins to flash (approximately 20 seconds). ...