Resetting the moonroof switch
The moonroof switch may not operate properly and need to be reset if any of the following conditions have occurred:
● the moonroof has been manually moved,
● the moonroof motor has been removed and
reinstalled after the moonroof has been repositioned
or adjusted,
● the moonroof glass panel has been adjusted
or changed, or
● the electrical supply interrupted and/or
some malfunction has been detected.
Use the following reset procedure to return the moonroof operation to normal.
1. Place the ignition switch in the ON position.
2. Push and hold the moonroof switch
toward 2 . Once the moonroof has
reached the full tilt position, release the
switch. Push and hold the switch toward
the 2 position again. After a delay of
four seconds, the moonroof will make a small
movement and backup.
3. Release the switch.
4. Within 5 seconds of releasing the switch,
push and continuously hold the switch
toward 2 . The moonroof will move
from the tilt position to the open position and
back to the close position.
NOTE:
If the switch is released at any time during Step 4, the procedure must be restarted.
5. Release the switch. Do not place the ignition switch in the OFF position for at least 2 seconds. The moonroof is now reset. If the moonroof still does not operate properly, have the moonroof system checked by a NISSAN dealer.
See also:
Continuously Variable
Transmission (CVT) position
indicator light (if so equipped)
When the ignition switch is placed in the ON
position, this indicator light shows the shift selector
position. See “Driving the vehicle” in the
“Starting and driving” section of this manu ...
OFF position
When the switch is in the OFF position 3 , the
map lights will not illuminate, regardless of the
condition. ...
Infants
Infants up to at least 1 year old should be placed
in a rear-facing child restraint. NISSAN recommends
that infants be placed in child restraints
that comply with Federal Motor Vehicle Safety
Stan ...