Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following.
1. Press and hold the desired HomeLink button. Do not release the button until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button.
4. The HomeLink indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons.
The HomeLink Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink button that was just programmed. This procedure will not affect any other programmed HomeLink buttons.
See also:
Upper tether anchor/key cylinder covers
CAUTION
Never force the covers into place because
the hinge pins can be damaged. Follow
the removal and installation instructions
to prevent inoperability of the covers. ...
If your vehicle is stolen
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLink. Consult the
Owners Manual of each device or call the manufacturer
...
V-6 Gas Mileage, Performance
One of the disappointing elements of the V-6 Frontier — and one that many
people in the market for a smaller truck will likely be concerned about — is its
gas mileage. With an automatic transm ...