Hood

1 Pull the hood lock release handle located

1 Pull the hood lock release handle located below the driver’s side instrument panel; the hood springs up slightly.
2 Lift the lever at the front of the hood with your fingertips and raise the hood.
3 Remove the support rod from the clamp.
4 Insert the support rod into the hole on the passenger’s side of the hood. 5

When closing the hood, return the hood rod to its original position. Lower the hood approximately 12 inches (30 cm) above the latch and release it. This allows proper engagement of the hood latch.

WARNING

● Make sure the hood is completely closed and latched before driving. Failure to do so could cause the hood to fly open and result in an accident.
● If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.

    See also:

    Rear folding seat system (if so equipped)
    Interior trunk access (if so equipped) The trunk can be accessed from the rear seat for loading and unloading, as shown. 1. Stow the outboard seat belts with the clip before folding the rear s ...

    Audio main operation
    Head unit: The auto loudness circuit enhances the low and high frequency ranges automatically in both radio reception and CD playback. PWR/Volume control: Place the ignition switch in the ACC o ...

    Continuously Variable Transmission (CVT) position indicator
    The Continuously Variable Transmission (CVT) position indicator indicates the selector lever position when the ignition switch is in the ON position. ...