CD care and cleaning
● Handle a CD by its edges. Do not bend the disc. Never touch the surface of the disc.
● Always place the discs in the storage case when they are not being used.
● To clean a disc, wipe the surface from the center to the outer edge using a clean, soft cloth. Do not wipe the disc using a circular motion.
● Do not use a conventional record cleaner or alcohol intended for industrial use.
● A new disc may be rough on the inner and outer edges. Remove the rough edges by rubbing the inner and outer edges with the side of a pen or pencil as illustrated.
Type A
1. Source select and Power on switch
2. Tuning switch
3. Volume control switch
Type B
1. Source select and Power on switch
2. Tuning switch
3. Volume control switch
Type C
1. Source select and Power on switch
2. Menu control switch/ENTER button
3. Volume control switch
See also:
Turn signal switch
Turn signal
(1) Move the lever up or down to signal the
turning direction. When the turn is completed,
the turn signals cancel automatically.
Lane change signal
(2)- To signal a lane cha ...
F.M.V.S.S./C.M.V.S.S. certification label
The Federal/Canadian Motor Vehicle Safety
Standard (F.M.V.S.S./C.M.V.S.S.) certification label
is affixed as shown. This label contains valuable
vehicle information, such as: Gross Vehicle
Weigh ...
Manual transmission (if so equipped)
● Do not downshift abruptly on slippery
roads. This may cause a loss of control.
● Do not over-rev the engine when shifting
to a lower gear. This may cause a
loss of control or ...