Control buttons

The control buttons for the Bluetooth Hands-

The control buttons for the Bluetooth Hands- Free Phone System are located on the steering wheel.

PHONE/SEND

Press the   button to

Press the initiate  button to initiate a VR session or answer an incoming call.

You can also use the to interrupt the system feedback button to interrupt the system feedback and give a command at once. See “List of voice commands” and “During a call” in this section for more information.

PHONE/END

While the voice recognition system

While the voice recognition system is active, press and hold the quit the voice recognition system button for 5 seconds to quit the voice recognition system at any time.

TUNING SWITCH

While using the voice recognition

While using the voice recognition system, tilt the tuning switch up or down to manually control the phone system.

    See also:

    Console light (if so equipped)
    The console light will turn on whenever the parking lights or headlights are illuminated. The console light brightness can be adjusted with the instrument brightness control. ...

    Push-Button Ignition Switch
    WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times in quick succ ...

    Heater operation
    Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. 1. Press the button to the OFF position for normal h ...