Choosing a language

You can interact with the Bluetooth Hands-Free Phone System using English, Spanish or French. To change the language, perform the following.

1. Press and hold the more button for more than 5 seconds.

2. The system announces: “Press the PHONE/SEND (hands-free phone system to enter the ) button for the hands-free phone system to enter the speaker adaptation mode or press the PHONE/END (different ) button to select a different language.”

3. Press the For information on speaker adaptation, see button. For information on speaker adaptation, see “Speaker Adaptation (SA) mode”in this section.

4. The system announces the current language and gives you the option to change the language to Spanish (in Spanish) or French (in French). To select the current language, press the PHONE/SEND (select a different language, tilt the tuning ) button. To select a different language, tilt the tuning switch ( or ) up or down.

NOTE:

You must press the 5 button within 5 seconds to change the language.

5. If you decide not to change the language, do not press either button. After 5 seconds, the VR session will end, and the language will not be changed.

    See also:

    Juke in the Market
    It's clear the Juke wasn't built for mass appeal. It rides too firm for some, and the cabin is too small for many. Driving fun, a few well-executed controls and reasonable value offer some vindica ...

    Vehicle Dynamic Control (VDC) off switch (if so equipped)
    Vehicle Dynamic Control (VDC) off switch (if so equipped) The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in ...

    Giving voice commands
    To operate NISSAN Voice Recognition, press and release the button located on the steering wheel. After the tone sounds, speak a command. The command given is picked up by the microphone, and v ...