Connecting procedure

NOTE:

The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled.

1. Press the button on the

1. Press the steering button on the steering wheel. The system announces the available commands.

2. Say: “Connect phone” A . The system acknowledges the command and announces the next set of available commands.

3. Say: “Add phone” B . The system acknowledges the command and asks you to initiate connecting from the phone handset C .

The connecting procedure of the cellular phone varies according to each cellular phone model. See the cellular phone Owner’s Manual for details. You can also visit www.nissanusa.com/bluetooth for instructions on connecting NISSAN recommended cellular phones.

When prompted for a Passkey code, enter “1234” from the handset. The Passkey code “1234” has been assigned by NISSAN and cannot be changed.

4. The system asks you to say a name for the phone D .

If the name is too long or too short, the system tells you, then prompts you for a name again.

Also, if more than one phone is connected and the name sounds too much like a name already used, the system tells you, then prompts you for a name again.

    See also:

    RearView Monitor (if so equipped)
    When the shift selector is shifted into the R (Reverse) position, the monitor display shows a rearward view from the vehicle. WARNING ● The system is designed as an aid to the driver in det ...

    Moving closer to a projecting object
    The position C is shown further than the position B in the display. However, the position C is actually at the same distance as the position A . The vehicle may hit the object when moving to ...

    Underbody
    In areas where road salt is used in winter, the underbody must be cleaned regularly. This will prevent dirt and salt from building up and causing the acceleration of corrosion on the underbody ...