Training procedure

The procedure for training a voice is as follows.

1. Position the vehicle in a reasonably quiet outdoor location.

2. Sit in the driver’s seat with the engine running, the parking brake on, and the transmission in P (Park).

3. Press and hold the more button for more than 5 seconds.

4. The system announces: “Press the PHONE/SEND (hands-free phone system to enter the ) button for the hands-free phone system to enter the speaker adaptation mode or press the PHONE/END (different ) button to select a different language.”

5. Press the For information on selecting a different language, button.

For information on selecting a different language, see “Choosing a language” in this section.

6. Voice memory A or memory B is selected automatically. If both memory locations are already in use, the system will prompt you to overwrite one. Follow the instructions provided by the system.

7. When preparation is complete and you are ready to begin, press the 8. The SA mode will be explained. Follow the button.

8. The SA mode will be explained. Follow the instructions provided by the system.

9. When training is finished, the system will tell you an adequate number of phrases have been recorded.

10. The system will announce that speaker adaptation has been completed and the system is ready.

The SA mode will stop if:

● The than 5 button is pressed for more than 5 seconds in SA mode.

● The vehicle begins moving during SA mode.

● The ignition switch is placed in the OFF or LOCK position.

    See also:

    Removing spots
    Remove tar and oil spots, industrial dust, insects, and tree sap as quickly as possible from the paint surface to avoid lasting damage or staining. Special cleaning products are available at a ...

    Tire Pressure Monitoring System (TPMS)
    Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard or tire infl ...

    Rear power sun shade (if so equipped)
    The rear sun shade operates when the ignition switch is in the ACC or ON position. The rear sun shade switch is located on the front console. - To raise the sun shade, push the upper side of ...