Manual control
While using the voice recognition system, it is
possible to select menu options by using the
steering wheel controls instead of speaking voice
commands. The manual control mode does not
allow dialing a phone number by digits. The user
may select an entry from the Phonebook or Recent
Calls lists. To re-activate voice recognition,
exit the manual control mode by pressing and
holding the PHONE/END (
) button. At
that
time, pressing the PHONE/SEND (
)
button
will start the Hands Free Phone System.
Operating tips
● To enter manual control mode, start the
voice recognition system and tilt the tuning
(
) switch up or down. The system
will
speak Showing Manual Options when
manual controls are initially activated.
● To browse the menu options, tilt the tuning
() switch up or down. The system
will
always speak the current menu option. Depending
on the audio display, it will also
show the current menu option.
● To select the current menu option, press the
PHONE/SEND ( ) button.
● To go back to the previous menu, press the
PHONE/END () button. If the current
menu is the Main Menu, pressing the
PHONE/END () button will exit the
Phone system.
● To exit the manual control mode, press and
hold the PHONE/END () button for 5
seconds.
See also:
Headlight aiming control (if so equipped)
Headlight aiming control (if so equipped)
Depending on the number of occupants in the
vehicle and the load it is carrying, the headlight
axis may be higher than desired. If the vehicle is
tra ...
Training phrases
During the SA mode, the system instructs the
trainer to say the following phrases. (The system
will prompt you for each phrase.)
● phonebook transfer entry
● dial three oh four two nin ...
After the operation
1. Lower the vehicle carefully to the ground.
2. Dispose of waste oil and filter properly.
- Prolonged and repeated contact
with used engine oil may cause skin
cancer.
- Try to avoid direct ...