Initialization
When the ignition switch is placed in the ON
position, NISSAN Voice Recognition is initialized,
which takes a few seconds. When completed,
the system is ready to accept voice commands. If
the 
switch is pressed before the
initialization
completes, the display will show the message:
“System not ready.” or a beep sounds.
See also:
Programming HomeLink
1. To begin, press and hold the two outer
HomeLink buttons (to clear the memory)
until the indicator light 1 blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held ...
Floor mats
To avoid potential pedal interference
that may result in a collision or injury:
- NEVER place a floor mat on top of
another floor mat in the driver front
position.
- Use only genuine NISS ...
Giving voice commands
1. Press the switch located on
the steering
wheel.
2. A list of commands appears on the screen,
and the system announces, “Would you like
to access Phone, Navigation, Information,
Audio or ...