Precautions on cruise control

● If the cruise control system malfunctions, it cancels automatically. The SET indicator light in the instrument panel then blinks to warn the driver.

● If the SET indicator light blinks, turn the cruise control switch off and have the system checked by a NISSAN dealer.

● The SET indicator light may blink when the cruise control switch is turned ON while pushing the ACCEL/RES, COAST/SET, or CANCEL switch. To properly set the cruise control system, use the following procedures.

WARNING

Do not use the cruise control when driving under the following conditions:
● When it is not possible to keep the vehicle at a set speed.
● In heavy traffic or in traffic that varies in speed.
● On winding or hilly roads.
● On slippery roads (rain, snow, ice, etc.).
● In very windy areas.
Doing so could cause a loss of vehicle control and result in an accident.

    See also:

    Vehicle set-up
    1. Park the vehicle on a level surface and apply the parking brake. 2. Start the engine and let it idle until it reaches operating temperature. 3. Turn the engine off and wait more than 10 min ...

    Tire rotation
    Tire rotation NISSAN recommends rotating the tires every 7,500 miles (12,000 km). See “Flat tire” in the “In case of emergency” section of this manual for tire replacing procedures. ...

    SAFETY
    The Murano CrossCabriolet has two sets of lower Latch anchors in the rear seats, but more importantly, the roomy backseat could easily house even the chunkiest infant carriers. With the top down ...