Changing engine oil filter

QR25DE

QR25DE

1. Park the vehicle on a level surface and apply the parking brake.
2. Turn the engine off.
3. Place a large drain pan under the oil filter A .
4. Loosen the oil filter A with an oil filter wrench by turning it counterclockwise. Then remove the oil filter by turning it by hand.

VQ35DE

VQ35DE

CAUTION

Be careful not to burn yourself. The engine oil may be hot.

5. Wipe the engine oil filter sealing surface with a clean rag.

CAUTION

Be sure to remove any old gasket material remaining on the sealing surface of the engine. Failure to do so could lead to engine damage.

6. Coat the gasket on the new filter with clean engine oil.

7. Screw on the oil filter until a slight resistance is felt, then tighten an additional 2/3 turn.

8. Start the engine and check for leakage around the oil filter. Correct as required.

9. Turn the engine off and wait more than 10 minutes. Check the oil level. Add engine oil if necessary.

    See also:

    Capacities and recommended fuel/lubricants
    The following are approximate capacities. The actual refill capacities may be slightly different. When refilling, follow the procedure described in the Maintenance and do-it-yourself section to de ...

    Control buttons
    The control buttons for the Bluetooth Hands- Free Phone System are located on the steering wheel. PHONE/SEND Press the   button to initiate a VR session or answer an incoming call. Y ...

    Equipment and model lines
    Just about the only conventional aspect to Nissan Juke is the model line-up, which follows Nissan's established Visia, Acenta and Tekna lines. Lists of standard and optional equipment will be rele ...